Ferrotec-W

Ferrotec-W2018-09-18T14:31:09+00:00

Corrosion protection for extremely high protection duration
chlorine, nitrite and barium free

Liquid corrosion protection with an extremely high protection duration for covered interim storage. The thin protective film which is like a soft wax and which is left after the evaporation of the solvent is stable to aging, does not crack/resinify and has a very high blocking effect against steams, gases, condensation and salts. Through the low level of viscosity, inaccessible areas are reliably moistened and protected. Water is infiltrated (dewatering effect) through special additives e.g. by cutting with water-miscible cooling lubricants.

Ferrotec-W fulfils the requirements of corrosion protection according to the VW regulation: PV 52.01 for all metals.

Ferrotec-W is used to protect ground and polished tools, machine components, injection moulding casts, sheeting and pipes.

Ferrotec-W is especially suited as corrosion protection for components and machines in wire erosion.

Ferrotec-W can easily be removed again, for instance with Tecusol…, Teculan-100 / -200 or Ferrolan-S,

Your advantage / your benefits

  • Easy to use
  • Free of harmful substances
  • Extremely tear-resistant and touch-dry
  • Prevents complaints
  • Saves expensive post-processing costs
  • Corresponds with the VW regulation PV52.02: – easy to remove – also subsequent to long storage periods
  • Improves safety enormously

How to use

Ready to use, by immersion, flooding, rolling and spraying.
Layer-weight from the immersion procedure: approx. 3-4g/m².
Drying time until the complete evaporation of the solvent: approx. 24 hours.
Protected plastic injection moulds do not need to be cleaned prior to installation. After a few cycles, the protective coating is completely removed.

Available in the following packaging

5103 Canister of 30 liters or 60 liters
Barrel of 200 liters
11116 500 ml aerosol can